EF Logo

J1939 · EGR

SPN 2791 FMI 6

EGR valve control current high or grounded

What does SPN 2791 FMI 6 mean?

The EGR valve control circuit shows high current or a short to ground. The ECM may switch the driver off to protect itself, so EGR stops working. Urgency: check soon - the machine may derate or limit a function. Check first: check the control wires for a short to ground with the ECM and actuator unplugged.

FaultCheckSPN 2791FMI 6J1939 engine ECU
FMI 6
Current above normal or grounded circuit

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Check the control wires for a short to ground with the ECM and actuator unplugged

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Control wire shorted to ground against the engine or a bracket
  • Actuator motor shorted internally
  • Harness burnt where it touches the exhaust manifold
  • Water in the actuator connector bridging the pins

How it failed

You'll notice: The EGR valve control circuit shows high current or a short to ground, so the ECM may switch the driver off to protect itself and EGR stops working.

Shorted lowRead from FMI 6: current above normal or grounded circuit

The signal sits at or near zero volts - less than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug both ends. Measure resistance from the signal wire to ground and to the machine frame.
Good result
Open circuit (OL) to ground. A low reading means chafed insulation touching metal.

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list shows SPN 2791 with FMI 6. The guidance on this page is general, not taken from it.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.