EF Logo

J1939 · EGR

SPN 2791 FMI 5

EGR valve control current low or open

What does SPN 2791 FMI 5 mean?

The EGR valve control circuit shows low current or an open circuit. The valve cannot move properly, so EGR flow is wrong. Urgency: check soon - the machine may derate or limit a function. Check first: measure the continuity of each control wire from the actuator plug to the ECM.

FaultCheckSPN 2791FMI 5J1939 engine ECU
FMI 5
Current below normal or open circuit

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Measure the continuity of each control wire from the actuator plug to the ECM

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Open wire between the EGR actuator and the ECM
  • Connector pin backed out or corroded at the actuator
  • Actuator motor coil open
  • Harness chafed through near the exhaust manifold

How it failed

You'll notice: The EGR valve control circuit shows low current or an open circuit, so the valve cannot move properly and EGR flow is wrong.

Open circuitRead from FMI 5: current below normal or open circuit

No current flows, or the signal floats - a wire, pin or coil is broken.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug both ends. Measure each wire end to end, then the part itself across its pins.
Good result
Near 0 Ω on each wire. The part reads its listed resistance, not OL.

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list shows SPN 2791 with FMI 5. The guidance on this page is general, not taken from it.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.