EF Logo

J1939 · EGR

SPN 2791 FMI 12

EGR actuator frozen

What does SPN 2791 FMI 12 mean?

The EGR actuator is stuck and not moving. The ECM cannot control EGR flow, so the engine can derate and show an emissions lamp. Urgency: check soon - the machine may derate or limit a function. Check first: command the valve and watch for any movement in the service tool.

FaultCheckSPN 2791FMI 12J1939 engine ECU
FMI 12
Bad intelligent device or component

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Command the valve and watch for any movement in the service tool

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Soot or carbon jam holding the valve shaft
  • Actuator motor failed
  • Valve shaft seized from heat and corrosion
  • Actuator supply or ground missing

How it failed

You'll notice: The EGR actuator is stuck and not moving, so the ECM cannot control EGR flow.

Part or controllerRead from FMI 12: bad intelligent device or component

The controller reports a part, module or its software as faulty or not responding.

ControllerPartSupplySignalGround?
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Check power and ground at the module connector with the key on, then its fuses.
Good result
Battery voltage on power, under 0.2 V drop on ground. Then it needs the service tool.

When to stop

Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Detroit Diesel DD15 2017-2020 fault codes list (Diesel Laptops)

This list shows SPN 2791 with FMI 12. The guidance on this page is general, not taken from it.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.