J1939 · EGR
SPN 2659 FMI 0
EGR flow too high
What does SPN 2659 FMI 0 mean?
EGR flow is above the target, the most severe level. Too much exhaust gas dilutes the intake charge, causing rough running, smoke and a derate. Urgency: check soon - the machine may derate or limit a function. Check first: command the EGR valve closed and watch the flow fall to zero.
- SPN 2659
- Engine EGR mass flow rate
- FMI 0
- Data above normal, most severe
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Command the EGR valve closed and watch the flow fall to zero
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Checks
0 of 5 done
Causes
- EGR valve stuck open or leaking
- Delta-P sensor reading wrongly high
- Hose to the delta-P sensor swapped or leaking
- Boost leak changing the pressure that drives the EGR flow
How it failed
You'll notice: EGR flow is above the target, the most severe level, so too much exhaust gas dilutes the intake charge and causes rough running, black smoke and a derate.
Real conditionRead from FMI 0: data above normal, most severe
The sensor reading is valid but outside the allowed range - the problem may be real.
- Meter test
- Check the real value with a separate gauge or thermometer before blaming the sensor.
- Good result
- If the gauge agrees with the display, fix the machine, not the sensor.
When to stop
Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other SPN 2659 codes
Source
Detroit Diesel DD15 2017-2020 fault codes list (Diesel Laptops)
This list shows SPN 2659 with FMI 0. The guidance on this page is general, not taken from it.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
