J1939 · EGR
SPN 2659 FMI 18
EGR flow too low
What does SPN 2659 FMI 18 mean?
EGR flow is below the target at the moderately severe level. Expect a derate, rough idle and an emissions lamp. Urgency: check soon - the machine may derate or limit a function. Check first: command the EGR valve and watch the flow reading in the service tool.
- SPN 2659
- Engine EGR mass flow rate
- FMI 18
- Below normal, moderately severe
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Command the EGR valve and watch the flow reading in the service tool
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Checks
0 of 5 done
Causes
- EGR cooler plugged with soot
- EGR valve stuck closed or slow
- Delta-P sensor or its hoses blocked, giving a false low flow
- Pipes or the venturi partly blocked with carbon
How it failed
You'll notice: EGR flow is below the target at the moderately severe level, so you may see a derate, rough idle and the emissions lamp, and the engine may smoke more at load.
Real conditionRead from FMI 18: below normal, moderately severe
The sensor reading is valid but outside the allowed range - the problem may be real.
- Meter test
- Check the real value with a separate gauge or thermometer before blaming the sensor.
- Good result
- If the gauge agrees with the display, fix the machine, not the sensor.
When to stop
Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other SPN 2659 codes
Source
Detroit Diesel DD15 2017-2020 fault codes list (Diesel Laptops)
This list shows SPN 2659 with FMI 18. The guidance on this page is general, not taken from it.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
