EF Logo

J1939 · Turbo

SPN 1172 FMI 4

Turbo compressor inlet temperature sensor voltage low

What does SPN 1172 FMI 4 mean?

The compressor inlet temperature sensor signal reads below its valid range, which the ECM sees as a short to ground or a lost supply. Urgency: check soon - the machine may derate or limit a function. Check first: key on, engine off: read the compressor inlet temperature sensor in the service tool; an impossibly hot reading on a cold machine means the ECM sees a short to ground.

FaultCheckSPN 1172FMI 4J1939 engine ECU
FMI 4
Voltage below normal or shorted low

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Key on, engine off: read the compressor inlet temperature sensor in the service tool; an impossibly hot reading on a cold machine means the ECM sees a short to ground

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Signal wire shorted to ground, which reads as an extremely hot temperature
  • Signal and return wires shorted together, or the compressor inlet temperature sensor element shorted internally
  • Harness against the turbo or exhaust heat shield, with melted insulation shorting the wires
  • Sensor wires pinched between the inlet pipe and a bracket
1 more cause
  • Oil mist from a turbo seal filling the plug

How it failed

You'll notice: The turbo inlet temperature is misread, so boost control and charge air corrections are a little off and the check-engine lamp comes on.

Shorted lowRead from FMI 4: voltage below normal or shorted low

The signal sits at or near zero volts - less than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug both ends. Measure resistance from the signal wire to ground and to the machine frame.
Good result
Open circuit (OL) to ground. A low reading means chafed insulation touching metal.

When to stop

Let the engine cool before opening the cooling system; a hot cap releases scalding coolant. Running on with an overheat warning risks a head gasket or seized engine.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list shows SPN 1172 with FMI 4. The guidance on this page is general, not taken from it.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.