J1939 · Turbo
SPN 1172 FMI 3
Turbo compressor inlet temperature sensor voltage high
What does SPN 1172 FMI 3 mean?
The compressor inlet temperature sensor signal reads above its valid range, which the ECM sees as a short to supply or an open signal line. Urgency: check soon - the machine may derate or limit a function. Check first: key on, engine off: read the compressor inlet temperature sensor in the service tool; a reading far below any real temperature, or at its minimum, means the ECM sees an open or high-voltage circuit.
- FMI 3
- Voltage above normal or shorted high
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Key on, engine off: read the compressor inlet temperature sensor in the service tool; a reading far below any real temperature, or at its minimum, means the ECM sees an open or high-voltage circuit
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Checks
0 of 5 done
Causes
- Open circuit between the compressor inlet temperature sensor and the ECM, so the ECM sees full pull-up voltage and reads an extremely cold temperature
- Signal wire shorted to a battery-voltage or 5 V wire in the harness, or an open sensor return
- Sensor pulled partly out of the inlet pipe or its grommet cracked
- Connector left off after an air filter or turbo pipe job
1 more causeFewer causes
- Wire broken where it is clipped to the intake pipe
How it failed
You'll notice: The turbo inlet temperature is misread, so boost control and charge air corrections are a little off and the check-engine lamp comes on.
Shorted highRead from FMI 3: voltage above normal or shorted high
The signal sits at or near the supply voltage - more than a working sensor can send.
- Meter test
- Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
- Good result
- Open circuit (OL) between them. Any low reading is the short.
When to stop
Let the engine cool before opening the cooling system; a hot cap releases scalding coolant. Running on with an overheat warning risks a head gasket or seized engine.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other SPN 1172 codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list shows SPN 1172 with FMI 3. The guidance on this page is general, not taken from it.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
