EF Logo

J1939 · Cooling

SPN 111 FMI 18

Coolant level low, moderately severe

What does SPN 111 FMI 18 mean?

The coolant level sensor reports the level low at the moderately severe level. The engine may run on, but low coolant leads to overheating. Urgency: stop now - shut down and fix before working on. Check first: check the coolant level cold and top up with the correct coolant mix.

FaultStopSPN 111FMI 18J1939 engine ECU
FMI 18
Below normal, moderately severe

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

Check the coolant level cold and top up with the correct coolant mix

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Coolant leak from a hose, the radiator, the heater core or the water pump seal
  • Tank not topped up after a service
  • Probe fouled with scale or deposits
  • Air pocket holding the level down after a refill

How it failed

You'll notice: The coolant level sensor reports the level low at the moderately severe level, so the dash warns of low coolant.

Real conditionRead from FMI 18: below normal, moderately severe

The sensor reading is valid but outside the allowed range - the problem may be real.

allowed rangetime
The reading against the band the controller allows.
Meter test
Check the real value with a separate gauge or thermometer before blaming the sensor.
Good result
If the gauge agrees with the display, fix the machine, not the sensor.

When to stop

Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list shows SPN 111 with FMI 18. The guidance on this page is general, not taken from it.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.