EF Logo

J1939 · Cooling

SPN 111 FMI 4

Coolant level sensor voltage low

What does SPN 111 FMI 4 mean?

The coolant level sensor signal reads below its valid range, which the ECM sees as a short to ground or a lost supply. Urgency: check soon - the machine may derate or limit a function. Check first: watch the coolant level sensor live with the key on; if it sits at its minimum straight away the fault is steady.

FaultCheckSPN 111FMI 4J1939 engine ECU
FMI 4
Voltage below normal or shorted low

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Watch the coolant level sensor live with the key on; if it sits at its minimum straight away the fault is steady

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Signal circuit grounded inside the harness between the coolant level sensor and the ECM
  • No supply at the coolant level sensor because the supply wire is broken or shared with another failed part
  • Coolant has leaked into the probe plug, grounding the signal through the wet connector
  • Real low coolant from a hose, radiator or water pump leak, giving a correct low reading
1 more cause
  • Lead rubbed through at the tank bracket and grounded

How it failed

You'll notice: The low coolant warning lights when the tank is full or never lights when coolant is short, so a real shortage can go unnoticed and the ECM may derate on a false low-level reading.

Shorted lowRead from FMI 4: voltage below normal or shorted low

The signal sits at or near zero volts - less than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug both ends. Measure resistance from the signal wire to ground and to the machine frame.
Good result
Open circuit (OL) to ground. A low reading means chafed insulation touching metal.

When to stop

Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list shows SPN 111 with FMI 4. The guidance on this page is general, not taken from it.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.