J1939 · Cooling
SPN 111 Fault Code
Engine coolant level
What does SPN 111 mean?
Coolant level in the surge tank, read by a level probe. The ECM uses it for low-coolant warnings and engine protection. How urgent it is depends on the FMI after SPN 111 - pick it below. Check first: check the coolant level by eye with the engine cold, then compare it with the sensor reading; a tank that is low while the sensor reads full points to a fouled probe.
- SPN 111
- Engine coolant level
- FMI ?
- How it failed - the number after the SPN
Can I keep running with it?
Depends on the FMI
How urgent it is depends on the FMI after SPN 111 - pick it below.
What should I check first?
Check the coolant level by eye with the engine cold, then compare it with the sensor reading; a tank that is low while the sensor reads full points to a fouled probe
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Which FMI shows after SPN 111?
You'll notice: The low coolant warning lights when the tank is full or never lights when coolant is short, so a real shortage can go unnoticed and the ECM may derate on a false low-level reading.
Find the number shown after SPN 111 on your display. 3 of them have their own page with causes and checks.
- 1SPN 111 FMI 1: Value is below the normal range, most severe levelReal conditionCummins ISX15, Detroit DD15, Detroit DD13, Detroit DD13 Gen 5 and 5 more
- 3SPN 111 FMI 3: Signal voltage is above normal, or the circuit is shorted to a high sourceShorted highCummins ISX15, Detroit DD15, Detroit DD13, Detroit DD13 Gen 5 and 5 more
- 4SPN 111 FMI 4: Signal voltage is below normal, or the circuit is shorted to a low sourceShorted lowCummins ISX15, Detroit DD15, Detroit DD13, Detroit DD13 Gen 5 and 5 more
- 5SPN 111 FMI 5: Current is below normal, or the circuit is openOpen circuitMack MP8, Mack MP7, Volvo D13
- 6SPN 111 FMI 6: Coolant level sensor circuit is reading lowShorted lowDetroit DD15, Detroit DD13
- 11SPN 111 FMI 11: Coolant level reading is unlikely and not trustedOtherPACCAR MX-13
- 14SPN 111 FMI 14: A special-instruction condition defined by the engine maker appliesOtherMack MP8, Mack MP7, Volvo D13
- 17SPN 111 FMI 17: Value is below the normal range, least severe levelReal conditionCummins ISX15
- 18SPN 111 FMI 18: Value is below the normal range, moderately severe levelReal conditionCummins ISX15, Mack MP8, Mack MP7, PACCAR MX-13 and 1 more
- 19SPN 111 FMI 19: Coolant level is lowLost messageDetroit DD15
Checks
0 of 5 done
When to stop
Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.
How urgent SPN 111 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Causes
- Signal high or open: open signal or return wire, or the signal touching a supply wire, at the coolant level sensor
- Signal low or shorted: signal wire grounded, or the supply to the coolant level sensor lost
- Real condition: real low coolant from a leak, so the level warning is correct
- Real condition: probe fouled with scale, rust or old coolant giving a false reading
1 more causeFewer causes
- Sensor: coolant sloshing and air bubbles around the probe making the reading flicker
Other Cooling codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list names SPN 111 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.
The source covers: Cummins ISX15 (2013-2018) and X15; same SPN on other J1939 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
