J1939 · Air intake
SPN 1078 Fault Code
Crankcase ventilation rotor speed
What does SPN 1078 mean?
Speed of the rotor inside the crankcase ventilation separator, which cleans oil mist from the breather flow. How urgent it is depends on the FMI after SPN 1078 - pick it below. Check first: with the engine off, spin the rotor by hand and check for free movement.
- SPN 1078
- Crankcase ventilation rotor speed
- FMI ?
- How it failed - the number after the SPN
Can I keep running with it?
Depends on the FMI
How urgent it is depends on the FMI after SPN 1078 - pick it below.
What should I check first?
With the engine off, spin the rotor by hand and check for free movement
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Which FMI shows after SPN 1078?
You'll notice: A rotor that is too slow or too fast means the separator is not working, so oil mist passes and crankcase pressure can rise.
Find the number shown after SPN 1078 on your display.
- 3SPN 1078 FMI 3: Crankcase ventilation rotor speed signal voltage is above normal, or the circuit is shorted to a high sourceShorted highPACCAR MX-13
- 4SPN 1078 FMI 4: Crankcase ventilation rotor speed signal voltage is below normal, or the circuit is shorted to a low sourceShorted lowPACCAR MX-13
Checks
0 of 5 done
When to stop
Make the machine safe before you start: on firm level ground, attachments down, key out.
How urgent SPN 1078 is depends on its FMI and whether the engine has derated. Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Causes
- Rotor bearing worn
- Rotor jammed by oil sludge
- Speed sensor failed
- Drive fault
Other Air intake codes
Source
PACCAR MX-13 2013-2016 fault codes list (Diesel Laptops)
This list names SPN 1078 and the FMIs above for the engines it covers. The guidance on this page is general, not taken from it.
The source covers: PACCAR MX-13; same SPN on other J1939 engines.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
