EF Logo

J1939 · Turbo

SPN 102 FMI 4

Intake manifold pressure sensor voltage low

What does SPN 102 FMI 4 mean?

The intake manifold pressure sensor signal reads below its valid range, which the ECM sees as a short to ground or a lost supply. Urgency: check soon - the machine may derate or limit a function. Check first: watch the intake manifold pressure sensor live with the key on; if it reads near zero from power-up the fault is steady.

FaultCheckSPN 102FMI 4J1939 engine ECU
FMI 4
Voltage below normal or shorted low

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Watch the intake manifold pressure sensor live with the key on; if it reads near zero from power-up the fault is steady

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Signal circuit touching ground in the harness, which drags the intake manifold pressure sensor reading to zero
  • Reference wire to the intake manifold pressure sensor open or shorted, so the sensor has nothing to power it
  • Pressure port or short hose to the manifold split or pulled off, so the sensor sees outside air only
  • Signal wire chafed against the manifold bracket or the turbo pipe
1 more cause
  • Connector filled with charge-air oil mist, which can leak signal to ground

How it failed

You'll notice: Boost reads wrong, so the ECM trims fuel and the engine feels down on power with extra smoke, and the check-engine lamp may come on.

Shorted lowRead from FMI 4: voltage below normal or shorted low

The signal sits at or near zero volts - less than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug both ends. Measure resistance from the signal wire to ground and to the machine frame.
Good result
Open circuit (OL) to ground. A low reading means chafed insulation touching metal.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list shows SPN 102 with FMI 4. The guidance on this page is general, not taken from it.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.