Develon · Hydraulic valve drivers
Develon Fault Code V000211
Pump P/V (B)
What does Develon code V000211 mean?
The controller reports a fault on the pump P/V (B) output, the proportional valve for the second main pump. Urgency: check soon - the machine may derate or limit a function. Check first: measure the pump B regulator coil with the connector unplugged and compare it with the manual figure for your model.
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Measure the pump B regulator coil with the connector unplugged and compare it with the manual figure for your model.
Then 3 more checksWhere this code shows
Switch the key on and open the monitor fault or service menu on the gauge panel to see active codes.
Checks
0 of 4 done
Causes
- Open or shorted coil on the pump B regulator valve
- Wire damage or a loose pin in the pump B harness branch
- Moisture or hydraulic oil in the valve connector
- Controller output fault on that channel
How it failed
You'll notice: Not listed in the Cummins engine table of the DX140LCR-3, which only has V000210 for the pump valves.
Lost messageRead from how the source describes the code
A module stopped hearing another on the data link, or the data came late or garbled.
- Meter test
- Key off. Measure resistance between CAN high and CAN low at the diagnostic connector.
- Good result
- About 60 Ω on a two-terminator J1939 link. About 120 Ω means one terminator or one leg is open.
When to stop
Lower attachments to the ground and relieve hydraulic pressure before loosening any fitting. Never feel for a leak with your hand - oil under pressure can inject through skin.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Same part, other failures: Pump and flow control proportional valves
- V000210Pump P/V (A)OtherCheck soon
- V000211Pump P/V (B)Lost messageCheck soon
- V000212Flow control P/V (C) 2-way lh-hOtherCheck soon
- V000213Flow control P/V (D) 2-way rh-hOtherCheck soon
- V000214Flow control P/V (E) rotating cwOtherCheck soon
- V000215Flow control P/V (F) rotating ccwOtherCheck soon
- V000216Flow control P/V (G)OtherCheck soon
Other Develon codes: Hydraulic valve drivers
- V010Cooling Fan Proportional Valve
- V011Auxiliary Proportional Valve
- V012Electronic MCV Boom Raise Proportional Valve
- V013Electronic MCV Boom Float Proportional Valve
- V014Electronic MCV Bucket Crowd Proportional Valve
- V015Electronic MCV Bucket Dump Proportional Valve
- V016Electronic MCV Option Proportional Valve1
- V017Electronic MCV Option Proportional Valve2
Related on Equipments Finder
Source
This source lists V000211 and its meaning. The guidance on this page is general, not taken from it.
The source covers: Doosan / Develon DX excavators and DL wheel loaders, per the table cited.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
