J1939 · Fuel system
SPN 654 FMI 5
Cylinder 4 injector circuit open or low current
What does SPN 654 FMI 5 mean?
The ECM sees the cylinder 4 injector circuit open or drawing too little current, so the injector cannot open properly. Urgency: stop now - shut down and fix before working on. Check first: read the cylinder 4 injector circuit status in the service tool and confirm it is an open or low-current fault.
- SPN 654
- Engine injector, cylinder 4
- FMI 5
- Current below normal or open circuit
Can I keep running with it?
Stop now
Shut down and fix before working on. Running on risks damage or the machine locks out.
What should I check first?
Read the cylinder 4 injector circuit status in the service tool and confirm it is an open or low-current fault
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Checks
0 of 5 done
Causes
- Injector coil open inside the cylinder 4 injector, so no current flows when the ECM fires it
- Intermittent open at the ECM pins for cylinder 4, from fretted terminals or moisture in the ECM connector
- Cylinder 4 harness rubbed through at a clip, leaving one wire open
- Cylinder 4 injector coil open, or a pin pushed back in its plug near the middle-rear of the cover
How it failed
You'll notice: The ECM sees an open or low-current circuit at the cylinder 4 injector (the fourth cylinder from the front, just behind the middle of the engine), so that cylinder may not fire.
Open circuitRead from FMI 5: current below normal or open circuit
No current flows, or the signal floats - a wire, pin or coil is broken.
- Meter test
- Key off, unplug both ends. Measure each wire end to end, then the part itself across its pins.
- Good result
- Near 0 Ω on each wire. The part reads its listed resistance, not OL.
When to stop
Common-rail fuel runs at very high pressure. Never open a high-pressure line or fitting with the engine running or just after it stops - a fine fuel jet can pierce skin.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other SPN 654 codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list shows SPN 654 with FMI 5. The guidance on this page is general, not taken from it.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
