EF Logo

J1939 · Engine speed/timing

SPN 636 FMI 2

Camshaft and crankshaft signals do not match

What does SPN 636 FMI 2 mean?

The camshaft and crankshaft signals do not match each other, so the ECM cannot confirm engine timing. The engine may crank without starting, run rough or stall. Urgency: stop now - shut down and fix before working on. Check first: compare the cam and crank signals while cranking in the service tool.

FaultStopSPN 636FMI 2J1939 engine ECU
FMI 2
Erratic or incorrect data

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

Compare the cam and crank signals while cranking in the service tool

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Crank or cam sensor weak or faulty
  • Timing gear worn, so the cam and crank are out of step
  • Tone wheel loose or damaged
  • Sensor wiring damaged or the connector corroded

How it failed

You'll notice: The camshaft and crankshaft signals do not agree, so the ECM cannot confirm engine timing.

Erratic or implausibleRead from FMI 2: erratic or incorrect data

The reading jumps, drifts or disagrees with the sensors around it.

allowed rangetime
The reading against the band the controller allows.
Meter test
Watch the live value on the service tool while you flex the harness and tap the connector.
Good result
A steady value that tracks the real condition. A jump while flexing is the loose pin or wire.

When to stop

Most sensor and wiring faults can be traced with a multimeter and the wiring diagram. Disconnect the battery before unplugging controllers; if the controller itself is suspect or needs programming, that needs the dealer’s service tool.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Detroit Diesel DD15 2017-2020 fault codes list (Diesel Laptops)

This list shows SPN 636 with FMI 2. The guidance on this page is general, not taken from it.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.