J1939 · Fuel system
SPN 157 FMI 18
Rail pressure sensor, wiring or control valve fault
What does SPN 157 FMI 18 mean?
The common rail is not reaching its target pressure. The ECM can cut fuelling to protect the system, which shows up as power loss, a derate or a shutdown. Urgency: stop now - shut down and fix before working on. Check first: compare the rail pressure with the commanded value at idle, mid load and full load.
- FMI 18
- Below normal, moderately severe
Can I keep running with it?
Stop now
Shut down and fix before working on. Running on risks damage or the machine locks out.
What should I check first?
Compare the rail pressure with the commanded value at idle, mid load and full load
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Checks
0 of 5 done
Causes
- Fuel filters plugged or air in the low-pressure side, so the pump cannot fill
- High-pressure pump worn and unable to build pressure under load
- Injector or rail relief valve leaking pressure back to the tank
- Pressure control valve or rail pressure sensor fault making the ECM misjudge the pressure
How it failed
You'll notice: The common rail cannot reach its target, so the ECM trims fuelling to protect the system.
Real conditionRead from FMI 18: below normal, moderately severe
The sensor reading is valid but outside the allowed range - the problem may be real.
- Meter test
- Check the real value with a separate gauge or thermometer before blaming the sensor.
- Good result
- If the gauge agrees with the display, fix the machine, not the sensor.
When to stop
Common-rail fuel runs at very high pressure. Never open a high-pressure line or fitting with the engine running or just after it stops - a fine fuel jet can pierce skin.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other SPN 157 codes
Source
Detroit Diesel DD15 2017-2020 fault codes list (Diesel Laptops)
This list shows SPN 157 with FMI 18. The guidance on this page is general, not taken from it.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
