EF Logo

J1939 · Fuel system

SPN 655 FMI 5

Cylinder 5 injector circuit open or low current

What does SPN 655 FMI 5 mean?

The ECM sees the cylinder 5 injector circuit open or drawing too little current, so the injector cannot open properly. Cylinder 5 (which fires second in the usual 1-5-3-6-2-4 order) may not fire, giving rough running and a power loss. Urgency: stop now - shut down and fix before working on. Check first: with the ECM connector off, check continuity of both cylinder 5 injector wires to the plug.

FaultStopSPN 655FMI 5J1939 engine ECU
FMI 5
Current below normal or open circuit

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

With the ECM connector off, check continuity of both cylinder 5 injector wires to the plug

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Broken wire or crushed terminal in the cylinder 5 injector harness
  • Wiring splice or in-line connector on the cylinder 5 branch corroded or pulled apart
  • Ground or supply feed shared with the cylinder 5 injector circuit lost at a connector
  • Open cylinder 5 injector coil or a pin pushed back in the plug toward the rear of the cover

How it failed

You'll notice: The ECM sees an open or low-current circuit at the cylinder 5 injector (the second cylinder from the rear, between cylinders 4 and 6), so that cylinder may not fire.

Open circuitRead from FMI 5: current below normal or open circuit

No current flows, or the signal floats - a wire, pin or coil is broken.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug both ends. Measure each wire end to end, then the part itself across its pins.
Good result
Near 0 Ω on each wire. The part reads its listed resistance, not OL.

When to stop

Common-rail fuel runs at very high pressure. Never open a high-pressure line or fitting with the engine running or just after it stops - a fine fuel jet can pierce skin.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list shows SPN 655 with FMI 5. The guidance on this page is general, not taken from it.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.