J1939 · Aftertreatment - SCR/DEF
SPN 4360 FMI 3
SCR intake temperature sensor circuit high
What does SPN 4360 FMI 3 mean?
The SCR intake temperature sensor signal reads above its valid range, which the ECM sees as a short to supply or an open signal line. Urgency: check soon - the machine may derate or limit a function. Check first: watch the SCR intake temperature sensor with the key on; an impossibly cold reading on a machine that has been running marks an open circuit.
- FMI 3
- Voltage above normal or shorted high
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Watch the SCR intake temperature sensor with the key on; an impossibly cold reading on a machine that has been running marks an open circuit
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Checks
0 of 5 done
Causes
- Broken wire or pulled-back pin at the SCR intake temperature sensor; an open thermistor circuit reads as very cold
- Return wire open or the signal touching a supply circuit, either of which reads as full voltage
- Sensor close to the DEF dosing valve with DEF crystals creeping into the plug and opening the circuit
- Lead pulled tight when the dosing mixer pipe was refitted, breaking a wire
1 more causeFewer causes
- Plug left off after the dosing valve or mixer was serviced
How it failed
You'll notice: The ECM cannot read the gas temperature at the SCR inlet, so it holds back DEF dosing because it cannot be sure the catalyst is warm enough.
Shorted highRead from FMI 3: voltage above normal or shorted high
The signal sits at or near the supply voltage - more than a working sensor can send.
- Meter test
- Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
- Good result
- Open circuit (OL) between them. Any low reading is the short.
When to stop
Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other SPN 4360 codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list shows SPN 4360 with FMI 3. The guidance on this page is general, not taken from it.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
