J1939 · Aftertreatment - DPF
SPN 3719 FMI 16
DPF soot level high
What does SPN 3719 FMI 16 mean?
The soot load in the DPF is above its warning threshold. The ECM wants a regeneration, and the lamp shows until it burns off. Urgency: check soon - the machine may derate or limit a function. Check first: start a parked regeneration with the service tool and let it finish.
- FMI 16
- Above normal, moderately severe
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Start a parked regeneration with the service tool and let it finish
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Checks
0 of 5 done
Causes
- Short trips or long idling that never let the filter regenerate
- Regeneration repeatedly interrupted or inhibited
- Delta-P sensor or hose fault inflating the soot estimate
- Poor combustion adding extra soot
How it failed
You'll notice: The soot load in the DPF is above its warning threshold, so the ECM wants a regeneration and the lamp shows until it burns off.
Real conditionRead from FMI 16: above normal, moderately severe
The sensor reading is valid but outside the allowed range - the problem may be real.
- Meter test
- Check the real value with a separate gauge or thermometer before blaming the sensor.
- Good result
- If the gauge agrees with the display, fix the machine, not the sensor.
When to stop
Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other SPN 3719 codes
Source
Detroit Diesel DD15 2017-2020 fault codes list (Diesel Laptops)
This list shows SPN 3719 with FMI 16. The guidance on this page is general, not taken from it.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
