EF Logo

J1939 · Aftertreatment - DPF

SPN 3719 FMI 0

DPF soot level very high

What does SPN 3719 FMI 0 mean?

The soot load in the DPF is far above its limit. The engine will derate and needs a service regeneration or a filter cleaning before it returns to normal. Urgency: stop now - shut down and fix before working on. Check first: run a service regeneration with the service tool.

FaultStopSPN 3719FMI 0J1939 engine ECU
FMI 0
Data above normal, most severe

Can I keep running with it?

Stop now

Shut down and fix before working on. Running on risks damage or the machine locks out.

What should I check first?

Run a service regeneration with the service tool

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Repeated failed regenerations
  • DPF plugged with soot or ash
  • Doser fault stopping heat generation
  • Delta-P sensor fault hiding the real load

How it failed

You'll notice: The soot load in the DPF is far above its limit, so the engine derates and needs a service regeneration or a filter cleaning before normal power returns.

Real conditionRead from FMI 0: data above normal, most severe

The sensor reading is valid but outside the allowed range - the problem may be real.

allowed rangetime
The reading against the band the controller allows.
Meter test
Check the real value with a separate gauge or thermometer before blaming the sensor.
Good result
If the gauge agrees with the display, fix the machine, not the sensor.

When to stop

Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Detroit Diesel DD15 2017-2020 fault codes list (Diesel Laptops)

This list shows SPN 3719 with FMI 0. The guidance on this page is general, not taken from it.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.