EF Logo

J1939 · Aftertreatment - DPF

SPN 3480 FMI 4

Aftertreatment fuel pressure sensor circuit low

What does SPN 3480 FMI 4 mean?

The aftertreatment fuel pressure sensor signal reads below its valid range, which the ECM sees as a short to ground or a lost supply. Urgency: check soon - the machine may derate or limit a function. Check first: key on, engine off: read the aftertreatment fuel pressure sensor in the service tool; a value pinned at the bottom of its range with a plausible real value points to a ground fault or no supply.

FaultCheckSPN 3480FMI 4J1939 engine ECU
FMI 4
Voltage below normal or shorted low

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Key on, engine off: read the aftertreatment fuel pressure sensor in the service tool; a value pinned at the bottom of its range with a plausible real value points to a ground fault or no supply

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Signal wire shorted to ground between the aftertreatment fuel pressure sensor plug and the ECM, or an open signal wire that the ECM pulls down
  • No 5 V reference at the aftertreatment fuel pressure sensor, from an open reference wire or another sensor on the same supply pulling it down
  • Real low fuel supply to the doser, which the sensor reads correctly
  • Signal wire chafed on the doser heat shield
1 more cause
  • Fuel-soaked plug leaking signal to ground

How it failed

You'll notice: The doser fuel pressure is misread, so the ECM can stop hydrocarbon dosing and regeneration, and the DPF lamp may stay on while the filter slowly fills.

Shorted lowRead from FMI 4: voltage below normal or shorted low

The signal sits at or near zero volts - less than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug both ends. Measure resistance from the signal wire to ground and to the machine frame.
Good result
Open circuit (OL) to ground. A low reading means chafed insulation touching metal.

When to stop

Common-rail fuel runs at very high pressure. Never open a high-pressure line or fitting with the engine running or just after it stops - a fine fuel jet can pierce skin.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list shows SPN 3480 with FMI 4. The guidance on this page is general, not taken from it.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.