J1939 · Engine speed/timing
SPN 1569 FMI 31
Engine protection torque derate - condition exists
What does SPN 1569 FMI 31 mean?
The ECM is cutting torque to protect the engine. This is a result code, so another fault such as coolant, oil, fuel or aftertreatment caused it, and fixing that clears the derate. Urgency: check soon - the machine may derate or limit a function. Check first: read all active and stored faults and fix the first one.
- FMI 31
- Condition exists
Can I keep running with it?
Check soon
The machine may derate or limit a function. Find the cause before the next shift.
What should I check first?
Read all active and stored faults and fix the first one
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Checks
0 of 5 done
Causes
- Another active protection fault such as oil, coolant or fuel
- Aftertreatment fault leading to a derate
- Fuel supply fault limiting power
- Coolant or oil limit reached
How it failed
You'll notice: The ECM is cutting torque to protect the engine, so power drops and a lamp shows; this is a result code and the real fault is stored alongside it.
Real conditionRead from FMI 31: condition exists
The sensor reading is valid but outside the allowed range - the problem may be real.
- Meter test
- Check the real value with a separate gauge or thermometer before blaming the sensor.
- Good result
- If the gauge agrees with the display, fix the machine, not the sensor.
When to stop
Repeated aftertreatment faults lead to an engine derate. Parked regenerations and dosing tests are run with the service tool; do not remove or bypass DPF or SCR parts.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other SPN 1569 codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list shows SPN 1569 with FMI 31. The guidance on this page is general, not taken from it.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
