EF Logo

J1939 · Cooling

SPN 110 FMI 3

Coolant temperature sensor voltage high

What does SPN 110 FMI 3 mean?

The coolant temperature sensor signal reads above its valid range, which the ECM sees as a short to supply or an open signal line. Urgency: check soon - the machine may derate or limit a function. Check first: key on, engine off: read the coolant temperature sensor in the service tool; a reading far below any real temperature, or at its minimum, means the ECM sees an open or high-voltage circuit.

FaultCheckSPN 110FMI 3J1939 engine ECU
FMI 3
Voltage above normal or shorted high

Can I keep running with it?

Check soon

The machine may derate or limit a function. Find the cause before the next shift.

What should I check first?

Key on, engine off: read the coolant temperature sensor in the service tool; a reading far below any real temperature, or at its minimum, means the ECM sees an open or high-voltage circuit

Then 4 more checks
Plug the service tool in hereDiagnosticport, 9-pin

Where to read it

Connect a J1939-capable scan tool to the 9-pin diagnostic port.

Checks

0 of 5 done

Causes

  • Open circuit between the coolant temperature sensor and the ECM, so the ECM sees full pull-up voltage and reads an extremely cold temperature
  • Signal wire shorted to a battery-voltage or 5 V wire in the harness, or an open sensor return
  • Sensor loosened in the housing, with coolant seeping past its threads into the connector
  • Harness stretched tight when the thermostat housing was refitted, breaking a wire
1 more cause
  • Connector left unlatched after thermostat or water pump work

How it failed

You'll notice: The temperature gauge reads cold or pegs hot, the radiator fan may run all the time or never, and the ECM can derate or shut the engine down on a false overheat reading.

Shorted highRead from FMI 3: voltage above normal or shorted high

The signal sits at or near the supply voltage - more than a working sensor can send.

ControllerPartSupplySignalGround
Typical three-wire sensor or two-wire coil. Your wiring diagram has the real pins.
Meter test
Key off, unplug the sensor and the controller. Measure resistance from the signal wire to the supply wire and to battery positive.
Good result
Open circuit (OL) between them. Any low reading is the short.

When to stop

Let the engine cool before opening the cooling system; a hot cap releases scalding coolant. Running on with an overheat warning risks a head gasket or seized engine.

Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.

Source

Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)

This list shows SPN 110 with FMI 3. The guidance on this page is general, not taken from it.

Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.

Machine down?

Get a replacement machine or a technician - suppliers in the UAE contact you.

Post a request
EquipmentsFinder

Need equipment? Have equipment?

Buyers post one request and get quotes from suppliers. Suppliers list free and reach active demand.