J1939 · Cooling
SPN 110 FMI 16
Coolant temperature high, moderately severe
What does SPN 110 FMI 16 mean?
Coolant temperature is above its limit at the moderately severe level. The ECM warns and can begin to derate before it reaches shutdown. Urgency: stop now - shut down and fix before working on. Check first: clean the radiator and charge air cooler fins and check for blockage.
- SPN 110
- Engine coolant temperature
- FMI 16
- Above normal, moderately severe
Can I keep running with it?
Stop now
Shut down and fix before working on. Running on risks damage or the machine locks out.
What should I check first?
Clean the radiator and charge air cooler fins and check for blockage
Then 4 more checksWhere to read it
Connect a J1939-capable scan tool to the 9-pin diagnostic port.
Checks
0 of 5 done
Causes
- Radiator or charge air cooler dirty on the air side, cutting heat rejection
- Fan clutch slipping or the fan drive weak
- Coolant level low or the system partly air-locked
- Water pump wear or a slipping belt cutting circulation
How it failed
You'll notice: Coolant temperature is above its limit at the moderately severe level.
Real conditionRead from FMI 16: above normal, moderately severe
The sensor reading is valid but outside the allowed range - the problem may be real.
- Meter test
- Check the real value with a separate gauge or thermometer before blaming the sensor.
- Good result
- If the gauge agrees with the display, fix the machine, not the sensor.
When to stop
Tilt, load and interlock cutouts are what keep a lift or telehandler from tipping. Never bypass or bridge one to keep working; get the fault found before anyone goes up or lifts again.
Call a technician if the checks above do not find the cause, if the code returns after clearing, or if the fix needs a service tool, a calibration or a software update.
Other SPN 110 codes
Source
Cummins ISX15 2013-2018 fault codes list (Diesel Laptops)
This list shows SPN 110 with FMI 16. The guidance on this page is general, not taken from it.
Checks, causes, the drawing and the meter test are general workshop guidance, not the maker's procedure. Codes can differ by serial number and software - confirm with the service manual or your dealer before replacing parts.
Machine down?
Get a replacement machine or a technician - suppliers in the UAE contact you.
