Bobcat T190 vs Kubota SVL75-3

The Kubota SVL75-3 is the heavier machine, at 4.27 t against 3.45 t, and the Kubota SVL75-3 has more power (54.6 kW against 45.5 kW).

The Bobcat T190 is ahead on: bigger fuel tank. The Kubota SVL75-3 is ahead on: more power, lifts or carries more.

Below, every figure both makers publish sits side by side, with the Bobcat T190 and the Kubota SVL75-3 drawn to the same scale from their dimension drawings.

Bobcat · compact track loader
Bobcat T190
Change modelFull specs PDF
Kubota · compact track loader
Kubota SVL75-3
Change modelFull specs PDF
Add a modelUp to four

At a glance

Bold is the machine ahead on each figure, with its lead.

Figure	Bobcat T190	Kubota SVL75-3
Operating weight	3,453 kg	4,273 kg
Net powerHigher is better	45.5 kW	54.6 kW+20%
Rated operating capacityHigher is better	1,088 kg	1,129 kg+4%
Fuel tankHigher is better	106 L+12%	94.6 L
Length with standard bucket	3.309 m	3.609 m

All specifications

Every figure the makers publish. Search for one, or show only those that differ.

Differences only(63)

FigureBobcat T190 Kubota SVL75-3

Dimensions

Operating height3.862 mNot published

Height with operator cab1.938 mNot published

Angle of departure30°31°

Ground clearance0.205 m0.296 m

Ground contact length1.401 m1.436 m

Length without attachment2.588 m2.844 m

Length with standard bucket3.309 m3.609 m

Rollback at ground position25°Not published

Dump height with standard bucket2.31 mNot published

Height to bucket hinge pin3.002 mNot published

Dump reach at maximum height0.784 m1.007 m

Dump angle at maximum height42°Not published

Rollback fully raised at maximum height95°Not published

Bucket width1.727 mNot published

Turning radius with standard bucket2.001 mNot published

Track width (gauge)1.356 m320 mm tracksNot published

Width over tracks1.676 m320 mm tracksNot published

Height to top of cabNot published2.078 m

Hinge pin height (max lift)Not published3.117 mbucket hinge pin height at max lift

Performance

Rated operating capacity1,088 kgNo more than 35% of tipping load1,129 kg35% of tipping load

Tipping load3,108 kgISO 14397-13,226 kg

Lift breakout force21 kN2,142 kgf

Tilt breakout force20 kNNot published

Top speed11.4 km/hNot published

Raise lift arms3.7 sFunction timeNot published

Lower lift arms2.4 sFunction timeNot published

Ground pressure33.8 kPa5.9 psi standard track / 4.8 psi wide track

Breakout forceNot published2,808 kgfbucket

Travel speed (high)Not published13.7 km/h

Travel speed (low)Not published9 km/h

Traction forceNot published4,390 kgf

Weight

Operating weight3,453 kgT190; 3,473 kg T190H4,273 kgclosed cab, including 75 kg operator

Shipping weight3,081 kgNot published

Engine

Engine modelKubota V2403M-DI-TE2B-BC-IKubota V3307-TE5A-CTL-Qturbocharged

Cylinders44

Displacement2.4 L3.3 L3,331 cc; bore x stroke 94 x 120 mm

Net power45.5 kW (61 hp)54.6 kW (73.2 HP)SAE J1349, at 2,400 rpm

Max torque235 NmGross, SAE J1995, at 1,475 rpmNot published

Gross powerNot published55.4 kW (74.3 HP)SAE J1995, at 2,400 rpm

Hydraulics

Pump flow62 L/minT190, at 3,028 rpm; gear pumpNot published

Pump flow (high flow)96 L/minT190HNot published

Max pressure22.4 - 23.1 MPaSystem relief at quick couplersNot published

Auxiliary flowNot published73 L/minstandard; 112.8 L/min high flow

Auxiliary pressureNot published224 kgf/cm2

Service capacities

Fuel tank106 L94.6 L

Engine oil, with filter8.7 LNot published

Cooling system11.3 LWith heater; 10.2 L withoutNot published

Hydraulic tank72.4 L16.1 L

Hydraulic system, with tank34.1 L46 L

Service intervals

Engine oil and filter250 hoursFirst change at 50 hNot published

Fuel filters250 hoursNot published

Hydraulic/hydrostatic filter500 hoursNot published

Hydraulic oil1,000 hoursNot published

Case drain filters1,000 hoursNot published

Hydrostatic motor carrier oil1,000 hoursAlso each time a track is replacedNot published

Pivot pins grease10 hoursLift arms, cylinders and Bob-Tach pinsNot published

Dimensions (top view)

Track gaugeNot published1.355 m

Overall widthNot published1.675 m

Width with standard bucketNot published1.717 m

Turning radius (rear)Not published2.936 mfrom centre, machine rear

Loader angles

Rollback angle at carry positionNot published27°

Max dump angleNot published39°

Undercarriage

Track widthNot published0.32 mstandard; 0.40 m wide track

Track rollers (per side)Not published4

Sources: Bobcat T190 Compact Track Loader Operation & Maintenance Manual 6904144-EN (09-06), Bobcat Europe, S/N 531711001 & above - Loader Specifications (manual pp.121-124), dealer-site copy · Kubota SVL75-3 brochure 8990C-01-AA (Kubota Australia, 2025-07)

Drawn to scale

Side views measured off each maker's dimension drawing, front edges and ground lined up.

Bobcat T190Kubota SVL75-3Same scale, front edges and ground lined up.

Bobcat T190 vs Kubota SVL75-3: questions

Which is bigger, the Bobcat T190 or Kubota SVL75-3?

By operating weight the Kubota SVL75-3 is the biggest at 4.27 t, then the Bobcat T190 at 3.45 t.

Which has more power, the Bobcat T190 or Kubota SVL75-3?

The Kubota SVL75-3: Bobcat T190 45.5 kW (61 hp), Kubota SVL75-3 54.6 kW (73.2 HP) (net power), a 20% difference.

Which lifts or carries more, the Bobcat T190 or Kubota SVL75-3?

The Kubota SVL75-3: Bobcat T190 1,088 kg, Kubota SVL75-3 1,129 kg (rated operating capacity), a 4% difference.

Which has the bigger fuel tank, the Bobcat T190 or Kubota SVL75-3?

The Bobcat T190: Bobcat T190 106 L, Kubota SVL75-3 94.6 L (fuel tank), a 12% difference.

Where do these figures come from?

Each model's own published spec sheet or brochure, linked under the table. Builds differ by market and year, so confirm the figures for a particular machine with its dealer.

Can I rent or buy these machines in the UAE?

Each model's page lists the ones for hire and for sale on EquipmentsFinder now, with typical prices in AED.